SEARCH
LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

LAND ROVER

RANGE ROVER VELAR

MUD FLAPS - FRONT

VPLYP0318

FITTING INSTRUCTION

WARNING

Accessories which are not properly fitted can be dangerous. Read the instructions carefully prior to fitting. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.

CAUTION

If protective wax has been applied to the vehicle it must be thoroughly removed before starting this procedure.
The vehicle must be clean, dry and at workshop temperature. Vehicles moved into the workshop from cold or wet conditions should be dried and left to stand for a minimum of 2 hours.

NOTE

Left side illustrations shown. Right side similar.

1

WARNING

The vehicle must be supported using suitable axle stands.

Raise and support the vehicle on a suitable lift.For additional information, please refer to the official Workshop Manual. Lifting (100-02)

2

Remove the bolt.

3

WARNING

Make sure to wear suitable personal protective equipment.

CAUTION

Allow to dry for a minimum of 60 seconds before proceeding to the next step.

Using the cleaner in supplied pack 'C', clean the illustrated area.

4

WARNING

Make sure to wear suitable personal protective equipment.

CAUTION

Allow to dry for a minimum of 60 seconds before proceeding to the next step.

Using the adhesion promoter in supplied pack 'D', wipe the illustrated area.

5

Remove and discard the backing from the adhesive strip.

6

Position the Mudflap as illustrated.
Apply pressure to the Mudflap on to the lower trim panel.
Install the bolt.
Torque: 5 Nm

7

CAUTION

Make sure that the retaining clips are positioned over the Mudflap and lower trim panel.

Using a suitable tool, install the retaining clips 'B'.