SEARCH
LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

LAND ROVER

RANGE ROVER VELAR

CLIP-ON WINDOW BLIND - TAILGATE

VPLYS0425

FITTING INSTRUCTION

WARNING

Accessories which are not properly fitted can be dangerous. Read the instructions carefully prior to fitting. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.

1

NOTE

There is only one clip (C). The clip (C) should be attached to the first clip-on window blind to be installed.
Part A is shown being installed first. Instructions are similar if part B is installed first.

Attach 1 clip (D) to the top of the clip-on window blind (A) as illustrated.
Attach 1 clip (D) to the base of the clip-on window blind (A) as illustrated.
Attach clip (C) to the center of the inner edge of clip-on window blind (A) as illustrated.

2

Install the clip-on window blind (A) to the tailgate window as illustrated.

Lower the clip-on window blind into position against the base of the tailgate window. Push clip (D) into the groove in the interior trim at the base of the tailgate window.
Push clip (D) into the groove in the interior trim at the top of the tailgate window.

3

Install the clip-on window blind (B) to the tailgate window as illustrated.

Lower the clip-on window blind into position against the base of the tailgate window. Push clip (D) into the groove in the interior trim at the base of the tailgate window.
Push clip (D) into the groove in the interior trim at the top of the tailgate window.

4

Attach the second clip-on window blind (B) to the clip (C). This will secure the 2 clip-on window blinds together.

5

To remove the clip-on window blinds.

Remove the clip (C) located between the 2 clip-on window blinds.
Pull down on the tab located at the top of the clip-on window blinds.