LAND ROVER ACCESSORY FITTING INSTRUCTIONS

VEHICLE :
PART NO :
KEYWORD :

LAND ROVER

RANGE ROVER VELAR

FRONT ILLUMINATED TREADPLATES

VPLYS0457PVJ

FITTING INSTRUCTION

WARNING
  • Accessories which are not properly fitted can be dangerous. Read the instructions carefully prior to fitting. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
REMOVAL INSTRUCTIONS
1

Remove the existing front treadplate from the vehicle.

  1. If the treadplate being removed is a front non illuminated treadplate then remove the part and proceed to install step 1.
  2. If the treadplate being removed is a front illuminated treadplate then continue to removal step 2.
2

Remove the electrical connector from the front illuminated treadplate that is being removed.

  • Remove the electrical connector from the mounting tab.
  • Release the electrical connector cable from the cable hook.
Fitting Instruction
NOTE
  • The following instructions are valid for both sides of the vehicle. The install procedure shows the front illuminated treadplate being fitted on the left side.
1

Locate the front illuminated treadplate electrical connector cable.

  1. Remove part of the vehicle carpet as illustrated to access the main wiring harness.
  2. Remove the tape that secures the front illuminated treadplate electrical connector cable to the main wiring harness.
2

Replace the vehicle carpet. Make sure the front illuminated treadplate electrical connector cable passes through the hole in the vehicle carpet as illustrated.

3

Feed the electrical connector cable through the hole in the vehicle carpet. Make sure there is sufficient cable length to connect to the socket on the front illuminated treadplate.

4

Connect the electrical connector, coming from the main wiring harness, into the socket on the front illuminated treadplate.

  1. Engage the electrical connector cable into the cable hook on the front illuminated treadplate.
  2. Engage the electrical connector into the socket on the front illuminated treadplate.
5

Align the 2 location pins, at either end of the front illuminated treadplate, with the 2 holes in the vehicle trim.

6

Attach the front illuminated treadplate to the vehicle. Make sure the 4 clips, on the front illuminated treadplate, locate into the 4 pockets in the vehicle trim.

7

Open the vehicle door and check that the front illuminated treadplate operates correctly.

© Land Rover 2016