• SEARCH
  • LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

VEHICLE :
PART NO :
KEYWORD :

LAND ROVER

DEFENDER

CHILD SEAT - GROUP 2/3 I-SIZE

VPLKS0688 / VPLKS0687 / T2H57417 / T2H57418

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to ordering and installation to make sure this accessory is applicable to your variant of vehicle. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
NOTE
  • These instructions are only for the removal of the child seat backrest to convert the seat into a child booster seat. For instructions on how to install the child / Booster seat to your vehicle scan the QR code at the end of these instructions.
Kits Required Market Part Number
Land Rover - Child Seat - Group 2/3 i-size ROW VPLKS0688
Land Rover - Child Seat - Group 2/3 China VPLKS0687
Jaguar - Child Seat - Group 2/3 i-size ROW T2H57417
Jaguar - Child Seat - Group 2/3 China T2H57418

Warnings / Cautions / Notes

WARNING
  • Child seat must always face forward.
  • Never secure your child or the child seat with a 2-point belt. Only use your vehicles 3-point seatbelts to fasten your child or the child seat.
NOTE
  • Please refer to your vehicles 'Owner's Handbook' for where you can place your child seat.
  • https://www.ownerinfo.landrover.com
  • https://www.ownerinfo.jaguar.com

Child Seat (Bill Of Materials)

REMOVAL INSTRUCTIONS
1

Unzip the lower backrest cover.

2

Unclip x2 backrest cover straps from the back of the seat.

3

Turn seat around and fold up the backrest cover to reveal x2 metal rods. Then use an appropriate tool to push in the metal rods to release them.

4

Turn seat around and remove the x2 metal rods.

  1. Pull metal rod upwards.
  2. Slide metal pin sideways to completely remove it.
5

Fold back the backrest then pull away from the booster seat to remove the backrest.

6

Booster seat.

Fitting Instruction
1

To install the backrest back to the booster seat locate the backrest pins into the booster seat at the same angle as it was when it was removed. Then fold backrest up to secure it into place.

2

Install x2 metal pins to the rear of the seat.

  1. Guide metal pin back into its original position.
  2. Push metal pin down to lock it into place. An audible click will be heard.
3

Turn seat around and inspect to make sure the pins are located back in there original positions. Then fold down the backrest cover and feed the straps under the backrest towards the back of the seat.

4

Turn seat around and connect the straps to the rear of the seat.

5

Zip up lower backrest cover.

6

Installation of Child / Booster seat to vehicle seats scan QR code for instructions.

© Land Rover 2016