SEARCH
LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

LAND ROVER

DEFENDER

LOADSPACE RAILS - 110

VPLES0543

FITTING INSTRUCTION

WARNING

Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.

NOTE

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
This procedure contains illustrations for left side components, right side components are similar.

1

Open the tailgate.

2

Remove the loadspace floor trim.

3

NOTE

This step must be completed on both sides of the loadspace.

Remove the illustrated trim.

Remove the fixed D-loop anchor points.
Remove and discard the 2 retaining bolts.
Remove and discard the trim.

1

Install the loadspace rail (A) and the 3 bolts (C).

Install the loadspace rail (A).
Install the 3 loadspace rail bolts (C).
Torque: 24 Nm

2

Adjust the sliding D-loop anchor points as required.

Unlock the D-loop anchor point.
Push down as illustrated.
Slide the D-loop anchor point to the required position.
Lock the D-loop anchor point.

3

Repeat install steps 1 to 2 to install the loadspace rail (B) to the right side of the loadspace.

4

Install the loadspace floor trim.

5

Close the tailgate.