LAND ROVER ACCESSORY FITTING INSTRUCTIONS

VEHICLE :
PART NO :
KEYWORD :

LAND ROVER

DEFENDER

LOADSPACE PARTITION NET - 110

LR133503

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to ordering and installation to make sure this accessory is applicable to your variant of vehicle. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
Kits Required Part Number
Loadspace Partition Net LR133503

Loadspace Partition Net (Bill Of Materials)

Bill Of Materials Replacement Service Part Number
(A) Loadspace Partition Net Available in complete kit only
(B) Storage Bag Available in complete kit only

Warnings / Cautions / Notes

WARNING
  • Third row seats must not be used when the 'Loadspace Partition Net' is installed.
CAUTION
  • Make sure to protect the vehicle paintwork and trim.
Fitting Instruction
NOTE
  • Following steps to be completed on both sides of the vehicle.
1

Use a suitable trim tool to open the loadspace partition mounting slot cover on both sides of the vehicle.

  1. Insert the trim tool into the cutout.
  2. Open the loadspace partition mounting slot cover.
2

Inspect the operation of the spring loaded fastener on both sides of the loadspace partition net.

3
NOTE
  • Make sure the logo on the loadspace partition net will be visible when standing at the rear of the vehicle and looking into the loadspace.

Lower 3nd row seats if applicable to your vehicle (refer to Owner's Handbook if required). Install the loadspace partition net (A) into the loadspace as illustrated.

4

Install the loadspace partition net spring loaded fasteners (A) into the loadspace partition mounting slot.

  1. Move the loadspace partition net so the spring loaded fastener is aligned with the larger circular slot as illustrated, then pull back on the spring load fastener.
  2. Insert the loadspace partition net into the mounting slot while still having the spring load fastener pulled back.
  3. Move the spring loaded fastener into the smaller circular slot and then release the spring loaded fastener .
5
CAUTION
  • If the vehicle has sliding D-loop anchor points then move 1 anchor point on each side of the vehicle to the rail position nearest to the second row seats and then lock the 2 anchor points.
NOTE
  • Do 'NOT' twist the straps in this process and keep the straps tight and straight.
  • When tightening the straps make sure the upper spring loaded fasteners are still located in the smaller circular slots in the roof liner. When correctly tensioned the spring loaded upper fixing point will retain in the small circular slots when a force is applied towards the front of the vehicle.

Secure the loadspace partition net straps to the fixed or sliding D-loop anchor points.

  1. Feed the Loadspace Partition Net strap down to and through the D-loop.
  2. Feed the Loadspace Partition Net strap up to and through the ratchet buckle while keeping the strap tight.
  3. Roll up the spare length of the loadspace partition net strap and then insert the rolled strap into the buckle. This will keep the vehicle loadspace tidy.
6

Make sure the loadspace partition net and all fasteners have a safe and correct installation. The straps should be tight and straight.

REMOVAL INSTRUCTIONS
1

Removal of loadspace partition net is the reversal of the install steps.

2

When the loadspace partition net is not being used it should be stored in the supplied storage bag (B).

© Land Rover 2016