SEARCH
LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

LAND ROVER

DEFENDER

LARGE PET ACCESS RAMP

VPLRS0517

FITTING INSTRUCTION

WARNING

Accessories which are not properly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
Only for use by animals.
Maximum ramp load 85 kg.
Only use the ramp on firm, flat and level ground.

NOTE

Make sure the rear bumper is clean and dirt free before use.
Quilted loadspace liner accessory with inbuilt bumper protector is recommended for use with this product.

1

Place the storage bag (B) in the vehicle loadspace with the zip section facing rearwards. Position the storage bag D-loops in proximity of the vehicle loadspace D-loops.

2

3

Using the supplied straps (C) attach the ramp bag to the loadspace D-loops using 2 of the D-loops on the storage bag.

Make sure the straps are tight.

4

Unzip the storage bag and remove the pet access ramp (A).

5

Unattach the strap on the pet access ramp.

6

CAUTION

Only hold the pet access ramp by the aluminium rails and end bar.

Extend the pet access ramp to its full length.

7

Place the pet access ramp securely on the rear bumper in line with the storage bag.

8

Attach the safety strap (D) to the rearward vehicle loadspace D-loop.

9

CAUTION

Make sure the strap is adjusted so the pet access ramp cannot accidentally fall from the rear bumper.

Tighten the safety strap as required.

10

When the desired strap length is acquired gather the excess strap using the buckle.

11

When packing away make sure the strap is reattached to the pet access ramp.

12

CAUTION

Make sure the strap is clear from the treadplate when closing the tailgate.

The safety strap can be left in place ready for future use.