LAND ROVER ACCESSORY FITTING INSTRUCTIONS

VEHICLE :
PART NO :
KEYWORD :

LAND ROVER

DEFENDER

CLICK & HANG UNIVERSAL HOOK

VPLRS0389

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.

Click and Hang Universal Hook (Bill of Materials)

Description Part Number Superseded By
Click and Hang Universal Hook VPLRS0389 VPLGS0593
Click and Hang Universal Hook VPLGS0593

Warnings / Cautions / Notes

WARNING
  • The Click and Hang Universal Hook does not restrain items placed on it. Items may come lose if the vehicle abruptly changes direction and may cause injury to the vehicle occupants.
  • Vehicle occupants are not permitted to sit behind the seat which the Click and Hang Universal Hook is installed to.
CAUTION
  • Do not exceed 1.5 Kg load on the Click and Hang Universal Hook.
  • Take suitable care not to damage the Click and Hang Universal Hook if the rear seats are folded down.
  • When not in use the Click and Hang Universal Hook should be stored in the luggage compartment.
NOTE
  • The click and go system base unit - VPLRS0388 only needs to be ordered if you vehicle is not fitted with the integrated backrest base unit that is shown in the graphic below on the left.
Fitting Instruction
NOTE
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
1

If your vehicle seats are installed with an integrated backrest base unit, raise and hold open the flap while installing the click and hang universal hook.

2

Push the hook fully into the click and go base unit. An audible click will be heard when securely in place.

REMOVAL INSTRUCTIONS
1

To remove hook.

  1. Press the buttons.
  2. Remove the hook.
© Land Rover 2016