SEARCH
LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

LAND ROVER

RANGE ROVER EVOQUE

REAR UNDERSHIELD

VPLZP0368

FITTING INSTRUCTION

WARNING

Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.

1

NOTE

Do not discard the undershield retaining screws.

Remove the 6 screws.

2

Release the 20 clips.
Disconnect the 2 electrical connectors.
Remove the rear bumper undershield and bumper trim assembly.

3

Release the 10 clips.
Remove the rear bumper undershield.

1

CAUTION

Make sure that the clips are correctly located.

Install the rear bumper trim panel.
Connect the 2 electrical connectors.
Secure the 20 clips.

2

Install the rear stainless steel undershield.
Secure the 8 clips.

3

NOTE

Make sure to align the outer corners of the component to line up with the original fixing points.

Install and tighten the 6 original screws to 3 Nm.

4

Make sure that the rear stainless steel undershield is aligned correctly.