• SEARCH
  • LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

VEHICLE :
PART NO :
KEYWORD :

LAND ROVER

RANGE ROVER EVOQUE

KAYAK CARRIER

VPLGR0107

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
WARNING
  • Do not exceed 130 Km/h (80mp/h).
  • Make sure the load is level.
  • Make sure the load is equally distributed and has no excessive overhang at the front or rear of the vehicle. Any overhang at the rear of the vehicle requires a warning flag.
  • Make sure the tailgate does not clash with the load.
  • Secure the load at each end.
  • Be aware of the increased height of the vehicle.
  • Do not use an automated car wash with the kayak carrier installed.
Fitting Instruction
1

Unlock and remove the roof cross bar side covers.

  1. Using the supplied key unlock the roof cross bar side covers.
  2. slide the side covers outwards.
  3. Move the roof cross bar side covers aside as illustrated.
2

Slide out both of the finishers from the roof cross bars.

3

Cut the roof cross bar finishers to length.

  1. Using a suitable cutting tool, cut the roof cross bar finishers using the measurements illustrated.
  2. Discard the smallest section of the roof cross bar finisher.
4

Install the roof cross bar finishers.

  1. Insert the roof cross bar finisher and the fixing (B) into the roof cross bar as illustrated.
  2. Install the roof cross bar side covers and lock.
5

Lower the kayak carrier onto the roof cross bar.

  1. Install the fixings (B and G) and the washers (E, D and F).
6
NOTE
  • Make sure the fixing is aligned with the lock before engaging.

Lock the kayak carrier to the roof cross bars.

  1. Slide the lock as illustrated.
  2. Lock using the key (L).
7

Lower the kayak carrier (K) onto the roof cross bar and secure with the fixings supplied.

8

Follow steps 4 to 8 for the other kayak carriers.

Fitting Instruction

Fitting Kayak Carrier Equipment.

1

Raise the kayak carriers as illustrated.

2

With assistance, place the load onto the kayak carriers.

3

Secure the load with the strap lock (J).

4

Lock the strap with the strap lock (J).

  1. Lift the cover.
  2. Press the strap lock.
  3. Thread the strap through the lock.
  4. Close the cover.
  5. Lock with the key (L).
5

Lift and slide the lock on the kayak carrier (K).

6

Release the strap.

7

Load the kayak carrier.

  1. Secure the strap.
  2. Lock the strap.
  3. Pull the strap tight.
8

Using the key, lock the kayak carrier.

9
WARNING
  • Do not exceed 130 km/h or 80 mph.

 

© Land Rover 2016