SEARCH
LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

LAND ROVER

DISCOVERY

WIND DEFLECTORS

VPLRP0284, VPLRP0279

FITTING INSTRUCTION

WARNING

Accessories which are not properly fitted can be dangerous. Read the instructions carefully prior to fitting. Whilst fitting, comply with instructions at all times. If in doubt, contact your nearest approved retailer.

CAUTION

Make sure the vehicle and components needed for the install are at workshop temperature.
Make sure the exterior of the vehicle is clean and free of any foreign material before starting the installation procedure.

CAUTION

Make sure the vehicle sits on a solid, level ground.

1

Front Door Wind Deflectors.

2

Clean the area as illustrated.

3

Wipe the area with a dry cloth.

4

Check proper fit and size of the wind deflector (A).

5

Clean the area, as illustrated, with the wipe cloth (E) supplied with the kit. Do not touch the cleaned area for five minutes.

6

Check the tolerances, as illustrated, and fit the wind deflector (A) to the appropriate side door. Mark the correct fitting position.

7

NOTE

The film does not need to be removed completely.

Peel off the adhesive as illustrated.

8

Install the wind deflector while paying attention to the fitting marks created previously.

9

Peel off and discard the remaining adhesive film from the wind deflector.

10

CAUTION

Take extra care not to damage the component.

Apply moderate pressure to the wind deflector for one minute.

11

Rear Door Wind Deflectors.

12

Clean the area as illustrated.

13

Wipe the area with a dry cloth.

14

Check proper fit and size of the wind deflector (B).

15

Clean the area, as illustrated, with the wipe cloth (E) supplied with the kit. Do not touch the cleaned area for five minutes.

16

Check the tolerances, as illustrated, and fit the wind deflector (A) to the appropriate side door. Mark the correct fitting position.

17

NOTE

The film does not need to be removed completely.

Peel off the adhesive film as illustrated.

18

Install the wind deflector while paying attention to the fitting marks created previously.

19

Peel off and discard the remaining adhesive film from the wind deflector.

20

CAUTION

Take extra care not to damage the component.

Apply moderate pressure to the wind deflector for one minute.

21

Check all installed wind deflectors for a safe and correct fit.

22

To get the adhesive appropriately set, keep the vehicle within the temperature range indicated for 24 hours.

23

To get the adhesive appropriately set, do not wash the vehicle for 24 hours.