• SEARCH
  • LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

VEHICLE :
PART NO :
KEYWORD :

LAND ROVER

RANGE ROVER

LOADSPACE PARTITION NET

VPLKS0614

FITTING INSTRUCTION

WARNING
  • Accessories which are not correctly installed can be dangerous. Please read the instructions carefully prior to installation. Comply with the instructions at all times. If in doubt, contact your nearest approved retailer.

Loadspace Partition Net (Bill of Materials).

Bill Of Materials Service Part Number
(A) Soft Cargo Barrier VPLKS0614
(B) Storage Bag

Warnings / Cautions / Notes

WARNING
  • Do not use 3rd row seats when loadspace partition net is installed. 3rd row seat should be in there stowed position.
CAUTION
  • Make sure to protect the vehicle paintwork and trim when installing.
  • If the loadspace partition net is to be used with a reclining seat, the seat must be moved into it's position before fitting the barrier.
REMOVAL INSTRUCTIONS
1

Open upper and lower tailgates.

2

Remove parcel shelf / power parcel shelf. Please refer to vehicles owner's manual for guidance.

3
WARNING
  • Ensure 2nd row seat belts are in seat belt guides and not trapped by the 7 seat side plates when fitted.

Fold down 2nd row seats and 3rd row seats if present.

4
NOTE
  • Place removed trim covers in secure location so that trim covers can be fitted back when loadspace partition net is removed.

Remove left and right trim covers without damage using the trim tool.

Fitting Instruction
1
NOTE
  • Make sure the logo (arrowed) on the loadspace partition net is facing to the rear of the vehicle on the left for the correct orientation.

Insert loadspace partition net upper guides into the large headliner fixing points and slide cargo barrier into the fixed position.

2
CAUTION
  • Make sure all the straps are tight and straight with no twisting.
NOTE
  • Both 5 seat and 7 seat variants shown.

Secure loadspace partition net to vehicle D-loops on both sides of the vehicle.

  1. Feed loadspace partition net straps through D-loops.
  2. Feed loadspace partition net straps through the buckle.
  3. Make sure straps are pulled through with maximum tension (when applying maximum tension this is when a bigger wave is seen in the loadspace partition net).
3
CAUTION
  • Make sure the 2nd row seat backrest does not touch the loadspace partition net in the reclined position.
  • If the loadspace partition net is to be used with a reclining seat, the seat must be moved into it's position before fitting the barrier. Or you can loosen the partition net then move the seat and retighten the net.

Fold up 2nd row seats.

4

Install parcel shelf / power parcel shelf. Please refer to vehicles owner's manual for guidance.

5

Close upper and lower tailgates.

6

Removal of the loadspace partition net is the reversal of the install steps. When not in use store loadspace partition net in the supplied bag (B).

© Land Rover 2016