SELECT YOUR LANGUAGE
Remove the front row seats.For additional information, please refer to the official Workshop Manual. Front Row Seat - Vehicles With: Power Seats (501-10)
Remove the floor console upper trim.For additional information, please refer to the official Workshop Manual. Floor Console Upper Trim (501-12)
Measure and mark and then drill a hole as illustrated.
Release the cup holder cover catch to reveal the front cup holder.
Drill a pilot hole from the underside of the cup holder approximately 10 mm from the rearward moulding.
Using the pilot hole as reference drill a 20 mm hole.
Cut out the centre of the sticky pad.
Install the pad onto the docking station.
Install the docking station.
Secure the grommet.
Remove the cup holder. For additional information, please refer to the official Workshop Manual. Floor Console Upper Trim (501-12)
Drill a hole in the area illustrated with a suitable tool.
Position the harness in the docking station base.
Install the tape onto the docking station.
With the floor console upper trim lowered feed the harness through the area shown to the rear of the unit.
Install the wiring harness to the previously cut floor console rear section.
Install the floor console upper trim.For additional information, please refer to the official Workshop Manual. Floor Console Upper Trim (501-12)
Install the front row seats.For additional information, please refer to the official Workshop Manual. Front Row Seat - Vehicles With: Power Seats (501-10)
Check the operation of the docking station.