SEARCH
LANGUAGE - English

LAND ROVER ACCESSORY FITTING INSTRUCTIONS

LAND ROVER

DEFENDER

LOADSPACE RETENTION NET

VPLWS0589, VPLCS0587, VPLCS0269

FITTING INSTRUCTION

WARNING

Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to installation. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.

NOTE

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.

	Specifications
MODEL	PART NUMBER
Range Rover Velar	VPLCS0587
Range Rover Evoque	VPLCS0587
Range Rover Evoque	VPLCS0269
Range Rover Discovery	VPLWS0589
Range Rover Discovery Sport	VPLCS0587
Range Rover	VPLWS0589
Range Rover Sport	VPLWS0589
Defender 110	VPLCS0587

1

Open the tailgate.

2

Remove the loadspace cover.

1

The loadspace retention net can be used if either the fixed D-loop anchor points or the sliding D-loop anchor points are installed.

2

NOTE

Complete step if the sliding D-loop anchor points are installed.

Move the 4 sliding D-loop anchor points to the ends of the loadspace rails.

3

Raise the loop on each of the 4 D-loop anchor points.

4

Install the loadspace retention net as illustrated.

5

There are 2 ratchet straps (B) that can be used to secure loads. These should be used if the load is too large for the loadspace retention net.

6

The ratchet straps should be tightened as illustrated.

7

The ratchet straps should be released as illustrated.

8

Install the loadspace cover if required.

9

Close the tailgate.