SELECT YOUR LANGUAGE
Remove the floor console upper section.For additional information, please refer to the official Workshop Manual. Floor Console Upper Section (501-12)
Remove the cup holder insert.
Drill a 21mm hole in the position as illustrated.
Install the cup holder insert.
Mark the 21mm hole on the cup holder as illustrated.
Make sure that the harness in the correct channel on the bottom of the docking station.
Install the tape onto the docking station.
Install the docking station to the cup holder insert.
Install the tape onto the cup holder insert.
Secure the docking station wiring harness to the cup holder.
Feed any excess wiring harness through the retaining clip where possible.
Secure the docking station wiring harness to the floor console main harness as illustrated.
Install the tape onto the docking station module.
Install the docking station module.
Connect the docking station harness into the main harness connector. Apply suitable foam tape to the T piece connector.
Install the floor console upper section.For additional information, please refer to the official Workshop Manual. Floor Console Upper Section (501-12)
Check the operation of the docking station.