SELECT YOUR LANGUAGE
Remove the floor console top finisher.For additional information, please refer to the official Workshop Manual. Floor Console Upper Section (501-12)
Remove the cup holder insert.
Drill a 21mm hole in the position illustrated.
Install the cup holder insert.
Mark the 21mm hole on the cup holder as illustrated.
Make sure that the harness in the correct channel on the bottom of the docking station.
Install the tape onto the docking station.
Install the docking station.
Install the tape onto the cup insert.
Install the docking station into the cup holder.
Align and install the docking station harness to the cup holder.
Pull harness through convolute to ensure no loose harness in cup holder as it is seated down.
Install the docking station harness to the floor console main harness as illustrated.
Measure and mark and then drill a hole as illustrated.
Install the harness to the floor console upper section.
Install the floor console upper panel.For additional information, please refer to the official Workshop Manual. Floor Console Upper Section (501-12)
Check operation of the docking station.