LAND ROVER ACCESSORY FITTING INSTRUCTIONS

VEHICLE :
PART NO :
KEYWORD :

LAND ROVER

DISCOVERY

FIRE EXTINGUISHER

VPLRS0334

FITTING INSTRUCTION

WARNING
  • Accessories which are not properly fitted can be dangerous. Read the instructions carefully prior to fitting. Whilst fitting, comply with instructions at all times. If in doubt, contact your nearest approved retailer.
NOTE
  • Left hand drive illustration shown, Right hand drive is similar.

VPLRS0334

2

3
WARNING
  • Always install the fire extinguisher to the front passenger side.

4

Open the front passenger door.

5

Position the front passenger seat fully rearwards.

6

Remove the plastic clips.

7

Install the template (I) to the position shown, then secure in place with the plastic clips removed in the previous step.

8

With a suitable tool cut the carpet along the indicated edges of the template. Note that not all template edges need to be cut along.

9

Remove and discard the plastic clips and the template.

10

Fold up the carpet section cut in the previous step.

11

With a suitable tool install the two rivet nuts (F).

12

Place the fire extinguisher bracket (C) to the appropriate position and fold down the carpet section.

13

Secure the fire extinguisher bracket and the carpet section with the torx bolts (D) and washers (E).

  • Torque: 9Nm.
14

Secure the fire extinguisher carrier (B) to the bracket.

  • Torque: 3Nm.
15

Cover the fire extinguisher carrier bolt holes with the two pieces of self adhesive foil (G) provided with the kit.

16

Put fire extinguisher (A) in the carrier and secure it with the strap.

17

Check the strap is correctly fastened.

18

Make sure the fire extinguisher is installed in the position shown.

19

Close the front door.

20

© Land Rover 2016