ANWEISUNGEN ZUM EINBAU VON ZUBEHÖR

Fahrzeug :
PART NO :
KEYWORD :

LAND ROVER

RANGE ROVER

LOADSPACE MAT

VPLKS0623 / VPLKS0624 / VPLKS0625

EINBAUANLEITUNG

WARNING
  • Accessories which are not correctly installed can be dangerous. Read the instructions carefully prior to ordering and installation to make sure this accessory is applicable to your variant of vehicle. Comply with instructions at all times. If in doubt, contact your nearest approved retailer.
Kit Variants Part Number
Rubber Loadspace Mat - 5 Seats VPLKS0625
Rubber Loadspace Mat - 5 Seats Executive VPLKS0623
Rubber Loadspace Mat - 7 Seats VPLKS0624

Rubber Loadspace Mat - 5 Seats

Rubber Loadspace Mat - 5 Seats Executive

Rubber Loadspace Mat - 7 Seats

Fitting Instruction
NOTE
  • This procedure contains some variation in the illustrations depending on vehicle specification, but the essential information is always correct.
1
NOTE
  • This step is 'ONLY' for vehicles with HVAC Control Module (HVAC) .

Before you install the loadspace mat. Check to see if your vehicle has a cut out in the left side loadspace trim for the extra tab on the loadspace mat. If not you will need to cut off this part as illustrated.

2

Install loadspace mat. If you need access to the D-Loops underneath the loadsapce then proceed with the following steps.

3
NOTE
  • For 5 seat vehicles 'ONLY'.

Remove loadspace mat from vehicle and cut where shown. This will allow access to the front and rear D-loops when installed.

4
NOTE
  • For 7 seat vehicles 'ONLY'.

Remove loadspace mat from vehicle and cut where shown. This will allow access to the rear D-loops when installed.

5
NOTE
  • 5 Seat variant shown. 7 seat similar but without the front D-loops cut out as they are located towards the front of the loadspace trim panel.

Install loadspace mat. Make sure it is laying correctly in the vehicle loadspace as illustrated and has access to the D-loops.

© Land Rover 2016